You have no items in your shopping cart.
0item(s)
You have no items in your shopping cart.
If you're pricing bulk network cable for a school, office remodel, or low-voltage retrofit, one question comes up fast: when should you use plenum cable? The short answer is when the cable will run through a plenum space, or when the job spec or local code requires a plenum-rated jacket....
Read more >A lot of cable purchases go wrong for a simple reason: the job gets reduced to speed alone. If you are asking what ethernet cable do I need, the real answer depends on three things - bandwidth, installation environment, and device power requirements. A short patch cable between a router...
Read more >If you are deciding between a poe injector vs switch for a camera, access point, or VoIP deployment, the right answer usually comes down to port count, power budget, and how much growth you expect. A single powered device in an existing network is a very different job than rolling...
Read more >If you are trying to figure out how to choose HDMI 2.1 cable, the fastest way to avoid a bad buy is to ignore marketing claims and start with your actual signal requirements. The right cable depends on resolution, refresh rate, run length, installation conditions, and whether the cable is...
Read more >If your monitor can run 144Hz, 240Hz, or higher, the wrong cable choice can leave performance on the table. That is why displayport vs hdmi gaming is not just a spec-sheet question. It affects refresh rate, resolution, adaptive sync support, audio handling, and how easily your setup works across PC...
Read more >