You have no items in your shopping cart.
0item(s)
You have no items in your shopping cart.
A camera will not normally fail just because it is plugged into a PoE switch. But can PoE damage devices? Yes, under the wrong conditions - especially when passive PoE, incorrect voltage, damaged cabling, or improperly matched equipment enters the installation. The key distinction is whether the equipment follows an...
Read more >A power cord that feels hot near the plug, connector, or along its jacket is not a normal operating condition. Why do power cords overheat? Usually, the cord or connection is carrying more current than it can safely handle, or resistance at a damaged or loose point is turning electrical...
Read more >A DisplayPort cable that is longer than necessary can create an avoidable troubleshooting call. A cable that is too short creates a different problem: strained connectors, awkward equipment placement, or an installation that has to be redone. The best DisplayPort cable lengths are the shortest lengths that reach comfortably, with...
Read more >A power cord that works loose behind a rack can take down a switch, server, PDU, display, or security recorder without warning. This locking power cord comparison focuses on the practical differences that matter when ordering replacement cords or specifying power connections for a new installation: how each connector locks,...
Read more >A BNC connector can look properly installed and still fail when the center pin is loose, the braid is trapped under the ferrule, or the wrong die compresses the sleeve. Knowing how to crimp BNC connectors correctly prevents intermittent camera feeds, video noise, signal loss, and expensive return visits. The...
Read more >